江蘇春晨電纜有限公司生產JEM電機引接線電氣二次電路圖中的電壓回路編號方法，

電氣設備安裝調試技術分析

Technical analysis of installation and debugging of electrical equipment

在安裝開始前要注意以下問題：變壓器安裝要做好絕緣檢查，注意選擇合理的安裝工具，確認變壓器安裝的位置和方式。在進行電氣設備安裝調試過程中，安裝人員要結合電氣設備的性能，制定好設備安裝調試工序，控制好每一 ...

Before installing, we should pay attention to the following problems: insulation inspection should be done for transformer installation, attention should be paid to selecting reasonable installation tools, confirming the location and mode of transformer installation. In the process of installation and commissioning of electrical equipment, the installation personnel should combine the performance of electrical equipment, set up a good equipment installation and commissioning process, control each of them well.

2017-10-23 15:43

2017-10-23 15:43

電氣圖紙會審常見問題JEM電機引接線電氣二次電路圖中的電壓回路編號方法

Common problems in electrical drawings

圖紙會審，就是細致熟悉施工圖紙的過程，審查出圖紙中存在的問題及不合理情況，并提交設計院、甲方、監理進行處理。圖紙會審過程中，需深入領會設計意圖、掌握工程特難點，找出需要解決的技術難題并擬定解決方案 ...

Is a comprehensive and detailed drawings, familiar with the process of construction drawings, drawings problems and unreasonable situation of a review, and submit the Design Institute, Party A, supervision process. In the process of drawing, to deeply understand the design intent, grasp the project special difficulties, find out the technical problems needed to solve and develop solutions...

2017-10-23 11:34

2017-10-23 11:34

電氣二次電路圖中的電壓回路編號方法

The method of voltage circuit numbering in electrical two circuit diagram

電氣二次電路圖中的電壓回路編號方法1、一號電源進線線路電壓互感器二次回路A相電壓回路編號為U610~U619，B相與C相U改為V與W；二號電源進線線路電壓互感器二次回路A相電壓回路編號為U620~629，B相與C相U改為V與W；中性線U改為N。 2、一段母線上的電壓互 ...

The voltage loop numbering method two electric circuit diagram of the 1, one power line line voltage transformer secondary circuit two A phase voltage loop number is U610~U619, B and C U to V and W; two, power line line voltage transformer secondary circuit two A phase voltage loop number U620~629 B phase and C phase change U to V and W; neutral line U to N. 2, a section of the bus voltage on each other...

2017-10-23 11:29

2017-10-23 11:29

零火線都帶電什么原因?怎么處理?JEM電機引接線電氣二次電路圖中的電壓回路編號方法

What's the reason for the line of zero fire line and how to deal with it?

零火線都帶電什么原因?怎么處理?具體情況不好說，但從經驗來看一種是偏相了造成零線帶電，這種情況在電網中不可避免，零線帶的電壓也不會太高，只要不是偏相偏的太離譜不影響正常使用。還有一種是斷了零線就比較麻煩了，以我們普通的樓房例子，一種 ...

The zero line are charged for what reason? How to deal with the specific circumstances? Not to say, but from experience is a partial phase caused by the zero line charged, this power is inevitable, with the zero line voltage is not too high, as long as not too outrageous offset does not affect the normal use. Another kind is the trouble of breaking the zero line, with the example of our ordinary building, one kind of..